Please updateYou use the tester's software in case you encounter this error.Starting with version 4.6.3, an error in the synchronization behavior of the testerFixed.

Nevertheless, canIf you use a CAN bus tester 2 or the CANtouchGet error frames displayed, but they are not available on the bus.

Since the test equipment usually do not affect the bus as passive devicesand error frames cannot communicate to other participants, these areFalse error frames

Not visible to other bus participants. When activatingthe log monitor, the testers become active bus subscribers and sendReal active error frames.

Then the testers behave like bus participantswith identical bitiming at the same plug-on position.

The testersare preset to strict bit-setting according to the CiA standard.

If you are inIf your bus use a different bit timing, then it may be thatTester sees error that other correctly set participants on the bus do notperceive.

remedyThe adjustment of the bit timing actually used in the bus also intesters.

BasicallyYou can also set a very tolerant bitiming in the tester.

Then haveYou can't tell if it's on your bus.Bittiming-related errors. The tester will always be with everythingbe satisfied. This has to be weighed.